Scott Drake Convertible Top with Plastic Curtain; Black (67-68 Mustang Convertible)Find parts that fit my vehicle

Firmly fastened

These nut fasteners made mounting my plate easy—snapped right into the factory holes and held tight. No rattles, no fuss. Simple part, but makes the job a whole lot easier. Classic Scott Drake quality.

Good part and good price

I was looking for this part in several websites but in all of them the shipping was even more expensive that the actual part so I bought this one because the shipping cost was fair, about the part there are no complains I haven't install yet but looks really nice and good quality also the packing was really good, thanks.

Great quality

These Scott Drake emblem barrel clips were a perfect fit for my 67 Mustang. They held the emblems securely in place and made installation easy. Great quality and a must-have for a clean restoration

Tight

I used these for installing a Scott Drake rear valence on my classic Mustang, and they worked exactly as they should. The finish is nice, and they feel sturdy—no cheap hardware here. Made the install a lot easier knowing I had the right pieces. Would definitely recommend if you’re restoring or replacing your valence!”

68 Bullitt Dash Panel Emblem

I used this as a dash panel Emblem but to match up with the original emblem I had to use a outer blank emblem to make it look original, easy installion, just pill off back and stick on.

Hinges replaced

These hi ges were ordered to replace a set the bent on installation. They are of better quality and fit perfectly.

Perfect Fit

This is a easy install a matches with the original part.

Mirrors

Look and fit were very nice…..nice to not have mirrors flopping around anymore.

Works great and (hopefully) stronger than stock

These Scott Drake hood bump stops fit my ‘69 Mustang perfectly. They’re well-made, easy to install, and keep the hood aligned properly. Great quality replacement!