Lower Outer Door Patch Panel; 7-Inch Tall; Driver Side (55-59 Chevrolet Truck)

Reproduction of the original outer lower door patch panel designed for use with 1955-59 Chevrolet and GMC pickup models. This tall patch panel is stamped in proper gauge steel with the correct slightly curved contour for an authentic appearance. Will allow replacement of the commonly rusted or damaged lower section without replacing the entire outer door skin. Comes with black EDP coating for rust resistance. Includes the bottom door edge and side lip for easier installation. Measures approximately 7" high.

NOTE: For use with 1955 2nd Series (late production) models.

1955 1st SERIES DESIGN - WHAT TO LOOK FOR: Chevrolet: 2 round dash gauges, left side gauge cluster, right side speedometer GMC: 6 gauge dash panel, outer gauges are staggered 6-volt electrical system 2-piece hood with a hood split molding Small curved windshield Fat front fenders that resemble the rear fenders 1955 2ND SERIES DESIGN - WHAT TO LOOK FOR Chevrolet: "V" shape speedometer/dash gauge cluster GMC: 6 gauge dash panel, outer gauges are over/under each other 12-volt electrical system One-piece full size hood Large curved wrap around windshield Front fenders are flush with the doors

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov